Obviously connect via the console cable, or from the outside interface, (because you’re about to remove the configured inside interface, until we recreate it again). ASA 5506-X Remove the BVI Interface From CLIįirst you have to remove the bridge group from the physical interfaces, but first you need to remove the interface name, or it will error. Has anyone discussed the options with the 5512/5515 models going end of life and whether or not they would consider the newer 2100 models versus the 5516/5525 models I had a few questions and was wondering if anyone has dealt with the new models coming out: 1 - Does the new 2100 series use. But to be honest I think its pretty bobbins! So I’ll be ripping it out of every 5506-X I deploy. ASA5515 End of Life Replacement 5516 vs 2100 models. Well if you are a small business and make very little changes to the firewall then this may be fine, (if a little cumbersome to setup).

Yes I’m not making it up, that’s the added default config for a new 5506-X firewall, (post version 9.7) if you issue a configure factory-default, that’s what you will get! ( Don’t panic: If you upgrade a firewall it wont add this in!) Is That What You Wanted? Same-security-traffic permit inter-interface I’ll shorten the default firewall config and show you the ‘added commands’ that are used for this configuration. Unless you have a very simple network that can get very complicated, very quickly! Also note, the same holds true for remote management via SSH/ADSM etc. Oh Great! So Just Like an ASA5505 Then? Well no sorry, I don’t like it because it needs an access-group/ACL for each bridged interface, and a NAT statement for each bridged interface.

ASA 5516-X Series Adaptive Security Appliance Legacy Models ASA 5512-X, 5515-X. So on the ASA 5506-X with a default configuration, it ‘Bridges’ interfaces Ge0/2 to Ge0/8, into one interface which you can call the inside interface an give it an IP address. End-of-Sale and End-of-Life Announcement for the Cisco ASA 5505 Adaptive. Well not strictly true, Cisco ASA has had BVI interfaces in ‘ transparent mode‘ for some time. To ‘fix’ the problem would probably mean changing hardware, so Cisco gave us a BVI, Bridge Virtual Interface instead (with version 9.7). Because it’s easier to sell a firewall that cost less than 500 quid, than it is to sell a firewall that fits the network requirements!

The problem was, people started throwing them in everywhere, I’ve seen them in large businesses, and in data centres. While I understand that, and if truth be told the ASA 5505, was SUPPOSED to be used in SOHO environments where an all in one device, (with PoE) was a great fit. Cisco ASA 5500-X with FirePOWER Services - Data Sheets Cisco ASA 5500-X with FirePOWER Services - Data Sheets Cisco FirePOWER Services - Learn product details such as features and benefits, as well as hardware and software specifications.When the ASA 5506-X appeared there was much grumbling, “This is not a replacement for the ASA 5505, I need to buy a switch as well!” and “I have six ports on the firewall I cant use” etc.

Asa 5516 end of life